[dune-pdelab] *** No rule to make target `doxygen-tag', needed by `install-doxygen'. Stop.

Markus Blatt markus at dr-blatt.de
Tue Jan 17 19:42:26 CET 2012


On Tue, Jan 17, 2012 at 02:09:12PM +0100, Victor Mataré wrote:
> 
> OK, here's what happened:
> I built dumux/dune with this command:
> 
> $ ./dune-common-2.1.1/bin/dunecontrol --module=dumux --opts=dumux-2.0.2/optim.opts all
> 
> And then tried to install with this command:
> 
> $ ./dune-common-2.1.1/bin/dunecontrol --module=dumux --opts=dumux-2.0.2/optim.opts make install
> 
> Documentation was built and installed correctly for all modules
> according to whatever default the build command implies. Except for
> pdelab, where the build defaults seem to be inconsistent with the
> installation defaults. However now that I explicitly specified
> --enable-documentation for the configure phase, the issue is worked
> around: 
> 
> $ ./dune-common-2.1.1/bin/dunecontrol --module=dumux --configure-opts="--enable-documentation" --all-opts=dumux-2.0.2/optim.opts all
> 

Would you please post a bug in flyspray
http://www.dune-project.org/flyspray/ and attach the config.log to it.
Otherwise it will  be hard to reproduce the bug.
Regards,

Markus
-- 
Do you need more support with DUNE or HPC in general? 

Dr. Markus Blatt - HPC-Simulation-Software & Services http://www.dr-blatt.de
Rappoltsweilerstr. 5, 68229 Mannheim, Germany
Tel.: +49 (0) 160 97590858  Fax: +49 (0)322 1108991658 




More information about the dune-pdelab mailing list