[Dune] installation fails - version mismatch dune-grid >= 2.5 required

Susanne Schmidt s.schmidt at sidata.eu
Fri Mar 23 11:02:21 CET 2018


Dear all,

newbie question - I am trying to install DUNE according to the 
information on the website 
https://www.dune-project.org/doc/beginners-resources-pdelab/

, on a fresh ubuntu 16.04.1 installation  in a virtual machine (some 
information on the setup below). [I want to use Navier Stokes, which is 
not included in the summerschool 2018 virtual machine]

After installing some missing bits and pieces (autoconf, automake, 
libtool, byacc, flex) I think that I am getting pretty far, until I hit:

"ERROR: version mismatch.

dune-alugrid requires dune-grid >= 2.5,

but only dune-grid = 2.4.2 is available.

Execution of dunecontrol terminated due to errors!"


The file ./buildmodules.sh in my-dune-dir is missing, so I cannot 
proceed from here, even if I thought that I could dispense of 
dune-alugrid and that the rest was in place.


I tried to outcomment the respective dune-alugrid bits in the 
installer.sh both in the folders pdelab-2.4.1 and pdelab-2.5.1 within 
the folder dune-installer, thinking that dune-grid MIGHT be sufficient 
for me (?), but then I am asked user name and password for the git which 
should not be required at this point? I tried email address and password 
for my access to the dune-website gitlab, but that's of course a 
different thing - the error message then says:

...

--- dune-istl done ---

--- done ---

+ checkout_dune_pdelab

+ for i in typetree pdelab

+ git clone https://gitlab.dune-project.org/pdelab/dune-typetree.git

Cloning into 'dune-typetree'...

Username for 'https://gitlab.dune-project.org': susanne_i_schmidt at yahoo.de

Password for 'https://susanne_i_schmidt@yahoo.de@gitlab.dune-project.org':

remote: The project you were looking for could not be found.

fatal: repository 
'https://gitlab.dune-project.org/pdelab/dune-typetree.git/' not found


So is this because my credentials do not extend as far as the actual 
dune-project, or what is going on?


And where exactly does this version check happen, i.e. could I 
circumvent it? Will a Dune installation work with the available 
dune-grid at all, so would it be sufficient to just switch off the 
version check at this particular point? Or should I change dunecontrol? 
But where do I find it?

Best regards and thanks,

Susanne



suse at suse-VirtualBox:~$ sudo lshw

[sudo] password for suse:

suse-virtualbox

description: Computer

product: VirtualBox

vendor: innotek GmbH

version: 1.2

serial: 0

width: 64 bits

capabilities: smbios-2.5 dmi-2.5 vsyscall32

configuration: family=Virtual Machine 
uuid=EFF09A18-8906-4AEC-B866-7558AB4DAA04

*-core

description: Motherboard

product: VirtualBox

vendor: Oracle Corporation

physical id: 0

version: 1.2

serial: 0

*-firmware

description: BIOS

vendor: innotek GmbH

physical id: 0

version: VirtualBox

date: 12/01/2006

size: 128KiB

capabilities: isa pci cdboot bootselect int9keyboard int10video acpi

*-memory

description: System memory

physical id: 1

size: 992MiB

*-cpu

product: Intel(R) Core(TM) i7-4980HQ CPU @ 2.80GHz

vendor: Intel Corp.

physical id: 2

bus info: cpu at 0

width: 64 bits

capabilities: fpu fpu_exception wp vme de pse tsc msr pae mce cx8 apic 
sep mtrr pge mca cmov pat pse36 clflush mmx fxsr sse sse2 syscall nx 
rdtscp x86-64 constant_tsc rep_good nopl xtopology nonstop_tsc pni 
pclmulqdq monitor ssse3 cx16 pcid sse4_1 sse4_2 x2apic movbe popcnt aes 
xsave avx rdrand hypervisor lahf_lm abm fsgsbase avx2 invpcid

*-pci

description: Host bridge

product: 440FX - 82441FX PMC [Natoma]

vendor: Intel Corporation

physical id: 100

bus info: pci at 0000:00:00.0

version: 02

width: 32 bits

clock: 33MHz

*-isa

description: ISA bridge

product: 82371SB PIIX3 ISA [Natoma/Triton II]

vendor: Intel Corporation

physical id: 1

bus info: pci at 0000:00:01.0

version: 00

width: 32 bits

clock: 33MHz

capabilities: isa bus_master

configuration: latency=0

*-ide

description: IDE interface

product: 82371AB/EB/MB PIIX4 IDE

vendor: Intel Corporation

physical id: 1.1

bus info: pci at 0000:00:01.1

version: 01

width: 32 bits

clock: 33MHz

capabilities: ide bus_master

configuration: driver=ata_piix latency=64

resources: irq:0 ioport:1f0(size=8) ioport:3f6 ioport:170(size=8) 
ioport:376 ioport:d000(size=16)


...

*-network

description: Ethernet interface

product: 82540EM Gigabit Ethernet Controller

vendor: Intel Corporation

physical id: 3

bus info: pci at 0000:00:03.0

logical name: enp0s3

version: 02

serial: 08:00:27:28:8d:18

size: 1Gbit/s

capacity: 1Gbit/s

width: 32 bits

clock: 66MHz

capabilities: pm pcix bus_master cap_list ethernet physical tp 10bt 
10bt-fd 100bt 100bt-fd 1000bt-fd autonegotiation

configuration: autonegotiation=on broadcast=yes driver=e1000 
driverversion=7.3.21-k8-NAPI duplex=full ip=10.0.2.15 latency=64 
link=yes mingnt=255 multicast=yes port=twisted pair speed=1Gbit/s

resources: irq:19 memory:f0000000-f001ffff ioport:d010(size=8)

*-generic

description: System peripheral

product: VirtualBox Guest Service

vendor: InnoTek Systemberatung GmbH

physical id: 4

bus info: pci at 0000:00:04.0

version: 00

width: 32 bits

clock: 33MHz

configuration: driver=vboxguest latency=0

resources: irq:20 ioport:d020(size=32) memory:f0400000-f07fffff 
memory:f0800000-f0803fff


...

*-bridge

description: Bridge

product: 82371AB/EB/MB PIIX4 ACPI

vendor: Intel Corporation

physical id: 7

bus info: pci at 0000:00:07.0

version: 08

width: 32 bits

clock: 33MHz

capabilities: bridge

configuration: driver=piix4_smbus latency=0

resources: irq:9

*-storage

description: SATA controller

product: 82801HM/HEM (ICH8M/ICH8M-E) SATA Controller [AHCI mode]

vendor: Intel Corporation

physical id: d

bus info: pci at 0000:00:0d.0

version: 02

width: 32 bits

clock: 33MHz

capabilities: storage pm ahci_1.0 bus_master cap_list

configuration: driver=ahci latency=64

resources: irq:21 ioport:d240(size=8) ioport:d248(size=4) 
ioport:d250(size=8) ioport:d258(size=4) ioport:d260(size=16) 
memory:f0806000-f0807fff

...

*-scsi:1

physical id: 4

logical name: scsi2

capabilities: emulated

*-disk

description: ATA Disk

product: VBOX HARDDISK

physical id: 0.0.0

bus info: scsi at 2:0.0.0

logical name: /dev/sda

version: 1.0

serial: VBf9c02f13-b2759569

size: 19GiB (21GB)

capabilities: partitioned partitioned:dos

configuration: ansiversion=5 logicalsectorsize=512 sectorsize=512 
signature=e66e690b

*-volume:0

description: EXT4 volume

vendor: Linux

physical id: 1

bus info: scsi at 2:0.0.0,1

logical name: /dev/sda1

logical name: /

version: 1.0

serial: cf6ebb08-ec90-40d8-9bb7-5dd0ad39a1b8

size: 18GiB

capacity: 18GiB

capabilities: primary bootable journaled extended_attributes large_files 
huge_files dir_nlink recover extents ext4 ext2 initialized

configuration: created=2018-03-21 18:44:28 filesystem=ext4 
lastmountpoint=/ modified=2018-03-23 09:15:06 mount.fstype=ext4 
mount.options=rw,relatime,errors=remount-ro,data=ordered 
mounted=2018-03-23 09:15:07 state=mounted

*-volume:1

description: Extended partition

physical id: 2

bus info: scsi at 2:0.0.0,2

logical name: /dev/sda2

size: 1022MiB

capacity: 1022MiB

capabilities: primary extended partitioned partitioned:extended

*-logicalvolume

description: Linux swap / Solaris partition

physical id: 5

logical name: /dev/sda5

capacity: 1022MiB

capabilities: nofs


--

Dr. Susanne Schmidt

Queichheimer Hauptstr. 16
76829 Landau
06341 9507550
0174 8432855

s.schmidt at sidata.eu
http://www.sidata.eu

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.dune-project.org/pipermail/dune/attachments/20180323/0c23909d/attachment.htm>


More information about the Dune mailing list